Formatting guidelines

  • Academic contribution to the field
  • Clarity of abstracts
  • Conformity with the journal’s stated aims and scope
  • Readability of articles:
  1. Language:
  • Is the language clear?
  • Are there grammatical mistakes?
  1. Graphic design and layout:
  • What is the quality of the diagrams?
  • Is the layout of the article clear?


Formatting guidelines

All manuscripts submitted for publishing in the journal “Computer & Communications Engineering” are expected to be free from language errors and must be written and formatted strictly according formatting guidelines.

Articles published in English.

Instructions for Preparation of Papers in Journal “Computer & Communications Engineering”

First Author, Second Author, Third Author

Abstract: The abstract should contain the most important information about the paper, excluding symbols and citations other than normal text. Maximum length of the abstract is 10 rows. Use font:Arial 10pt Italic. Paragraph formatting: Line Spacing Single, Indentation Left 1cm, Right 1cm; Alignment Justified.
Key words: 1-2 lines, up to 10 in alphabetic order


1. Introduction

In order to affect the authors are requested to follow instructions given in this sample paper. The recommended text processor is Microsoft Word 97/2000/XP/2003.

Table 1. The font size and appearance for the styles

Style Font
TITLE 16 Bold
Authors 12 Bold
Abstract 10 Bold/Italic
Keywords 10 Bold/Italic
Heading 10 Bold
Text 10 Normal
Subheadings 10 Bold/Italic
Figure Caption 10 Bold/Italicl
Table Caption 10 Bold/Normal
References 9 Normal
2. Page Layout

The length of the full regular paper should not exceed two columns pages of A4 format, with space between columns 5 mm. The page setup is: top and bottom margins 25 mm, inside margin 17 mm, outside 18 mm. The text of the paper is in two columns width 85 mm, Spacing 5mm, Equal column width is marked.
Do not number the pages. On the last page of your paper, equalize the length of the columns.

3. Font and Styles

It is recommended to use Arial font. Several styles for different sections of paper are supplied. The title, authors, figure captions and equations are centered. The headings and subheadings and table captions are left aligned. The font size and appearance for the styles to be used in the full paper are shown in Table 1.

4. Figures, Tables and Equations

Tables and figures can be centered in columns. Table captions should be over the table, as in Table 1. Each figure must have a figure caption under the

figure. For the table and figure captions 10 pt font should be used. In some cases it is allowed to make two column wide tables and figures, but at this case they must be located at the top or the bottom of the page. All figures must be mentioned in the text. please use the following expressions: Eqn. (1), Eqns. (1) and (2), Fig. 1, Figs. 1 and 2, Table 1, Tables 1 and 2, [1], [2]. When submitting the full paper, send electronic *doc and *pdf version and a hard copy.

Fig. 1. This is the figure caption


[1] F. Author, S. Author, Title of the book with only first letter capitalized, Editor, 2004, London.
[2] F. Author, S. Author, Title of paper with only first letter capitalized, Journal name, Vol. 1, No 2, pp. 150-155, 2004.
References should be numbered using “Numbering”, to have zero mm first line and hanging of 6 mm.
All references should be numbered in square brackets both in the list of references and when citing them [1]. When the book or paper is not in English, give the original title.


About the authors:
First name, last name, affiliation and information.

Equations should be centered and numbered flush left, as in Eqn. 1.

(1)                    ,

5. Conclusion

When you refer to an equation, a figure, a table and a literature reference in the text of manuscript